Triton TRPUL Use and Care Manual download pdf (Page 11)

Maintenance

WARNING: Always ensure that the tool is switched off and the plug is removed

from the power point before making any adjustments or maintenance

procedures.

General inspection

• Regularly check that all the ﬁxing screws are tight. They may vibrate loose

over time

• Inspect the supply cord of the tool, prior to each use, for damage or wear.

Repairs should be carried out by an authorised Triton service centre. This

advice also applies to extension cords used with this tool

Drive belt replacement

It is suggested that you wear leather gloves to change the belt in case you

make contact with the blades

1. To replace the drive belt ﬁrst take out the ﬁve crosshead screws that

secure the drive belt cover on the left-hand side of the planer as viewed

from the rear 2. Remove the damaged belt and use a soft brush to clean

the pulleys and the surrounding area

Note: Wear eye protection when cleaning out the pulley area.

3. With the four continuous ‘V’ proﬁles on the inside, place the new belt over

the bottom pulley

Half ﬁt the other end of the belt on the top pulley then roll the belt in place

whilst turning the pulley

4. Check that the belt runs evenly by manually turning the belt

5. Replace the cover and the ﬁve ﬁxing screws

6. Connect the tool to the power supply and run the planer for a minute or two

to make sure that the motor and belt are operating correctly

Cleaning

WARNING: ALWAYS wear protective equipment including eye protection and

gloves when cleaning this tool.

• Keep your tool clean at all times. Dirt and dust will cause internal parts to

wear quickly, and shorten the device’s service life

• Clean the body of your machine with a soft brush, or dry cloth

• Never use caustic agents to clean plastic parts. If dry cleaning is not

sufﬁcient, a mild detergent on a damp cloth is recommended

• Water must never come into contact with the tool

• Ensure the tool is thoroughly dry before using it

• If available, use clean, dry, compressed air to blow through the ventilation

holes (where applicable)

Lubrication

• Lubricate all moving parts with a suitable lubricant spray, at regular

intervals

Storage

• Store this tool carefully in a secure, dry place out of the reach of children

Disposal

Always adhere to national regulations when disposing of power tools that are

no longer functional and are not viable for repair.

• Do not dispose of power tools, or other waste electrical and electronic

equipment (WEEE), with household waste

• Contact your local waste disposal authority for information on the correct

way to dispose of power tools

837520_Z1MANPRO2.indd 10 16/07/2014 14:20

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Comments to this Manuals

No comments

Triton TRPUL Use and Care Manual Page 11

Comments to this Manuals

Related products and manuals for Power planers Triton TRPUL